Panzer 1 Builds

[jee]

wow awesome

[Herr Dr. Professor]

"...so I built a brass idler arm.... I then made a Delrin insert...the shock absorber is a 4 mm brass rod turned down to 1mm.... The top cap is shaped to fit into the slot in the hull. The bottom cap has a 1mm hole in so that there is a tail in it to fit into an elongated slot hole cut in the swing arm."

Dogberry: I am so far from your level of skill that I can only gasp with my jaw hanging open. I read and admire...and admire...and admire...

[Panzermechaniker]

Yes that is awesome engineering on display.

[Winterhammermodels]

Great build.
I designed the gearbox. AS you mentioned, printing the cone gears could be Not so easy.
But great solution with the Brass gears.
I used recycled Pla for the gears, an they are stronger than petg printed gears.

[Dogberry]

Winterhammermodels

Can I commend you on a well thought out solution to fitting motors to the Tacom Panzer 1 hull. I admire your work. I like your gearboxes.

[MonsieurTox]

I like it very much, you did an awesome job converting it to RC !

[Meter rat]

Great builds.

[MrChef]

Such Awesome work Dogberry

I've always wanted to do a Panzer II.