DBC2RCHL need help

[BZ123456]

I am using dbc2rchl and lipo 2s 5800mAH. When playing around, sometimes the system fails and need to restart. I also use fan on top of MFU 18 to cool it down.
My question is, is this symptom from dbc or from overheating MFU? I know sometimes dbc has out of syncronize with MFU, its written in the manual, but this is really annoying.
If this is from dbc, then I need to rethink swap it with Clark system....

[Tankbear]

This normally happens when the voltage drops to low for the receiver and the receiver shuts down. You can try feedthe receiver from a 6v battery to see if this stops it happening.

Ian.

[BZ123456]

Thank you Tankbear, I will report the result.

[Tankbear]

This might help

http://battlearmorrc.weebly.com/brownouts-be-gone.html

What receiver are you using? as this might be more sensitive to the problem than others.

Ian.

[BZ123456]

I am using futaba FX30 with cheap orangeRX FASSTcompatible S-S
Wow thank you for link Tankbear, I will pass it on to our community, Indonesian RC Tank Community

[Tankbear]

Another option is to check the voltage to the receiver or servo leads. I know the DBC has a voltage stabaliser which caps the voltage to I think about 5v (Maybe Dan from the link I posted before can confirm).

If for some reason that is capping the voltage too low that could cause the receiver to shut off to soon.

Ian.

[BZ123456]

If I use lipo 2s to supply the DBC, it will be okay right? Because the DBC can handle up to 12 volt?

[Tankbear]

Yeah should be. I run one tank with a 9.6v 8cell battery (although through the MFU18) and no issues to date. So I think 7.4v LiPo to the DBC will be fine.

Ian.

[BZ123456]

Ian,

It works! Thank you for the advice....now I can travel miles away without worry because it has 3 cameras inside and immersionrc video transmitter 600mwatt and Eagle Tree OSD for FPV.

Thank you again
Benny

[Tankbear]

Glad you sorted it out.

Ian.