Another Tamiya Leopard A4

[HERMAN BIX]

Oven cleaner but wear gloves !!

[tankme]

Yeah a paint stripper will help you out a lot with that. I didn't notice the issue in smaller pictures on my phone.

People swear by the Testor's ELO stuff although its a bit pricey-

https://www.hobbylinc.com/testors-easy- ... ver-542143

Now lets try to figure out what happened with your paint so it doesn't happen a second time.

Whatever people say DO NOT try Brake fluid. I did, and it was the wrong thing to do and not worth it as well as cleanup.

Yeah, brake fluid eats plastic and paint. I have also heard oven cleaner works.

[Meter rat]

Welcome to the incompetent world of Meter Rat. Went old skool. A further two hours with wet and dry, used wet got it back to good plastic, and sound paint. I am rather pleased that I made such a cock up, as it has allowed me to address a lot more issues that were highlighted.

IMG_6296.jpeg (380.01 KiB) Viewed 237 times

Grey etch primer on tonight. And then try not to rush.

[Stormbringer]

Really hope the priming goes smoothly for you mate as that was a lot of hard work to get it back to that stage
do you think maybe a lower coat hadnt dried properly before you put next coat on ?

[Meter rat]

The paint came good in the end. Much sanding and filling was required. Made up a new mantlet cover but again unhappy with it so will make a new one.

IMG_6298.jpeg (116.71 KiB) Viewed 93 times

IMG_6299.jpeg (97.36 KiB) Viewed 93 times

[Stormbringer]

That really does look a lot better mate

[Meter rat]

Made a start on painting some of the small details. Rewired the lights to enable headlights and taillights,

IMG_6338.jpeg (54.99 KiB) Viewed 44 times

IMG_6339.jpeg (68.46 KiB) Viewed 44 times

to switch separately to the convoy lights.

IMG_6337.jpeg (59.09 KiB) Viewed 44 times

IMG_6340.jpeg (59.73 KiB) Viewed 44 times

IMG_6341.jpeg (49.55 KiB) Viewed 44 times

The cover between the main gun and the turret was also made to be removed easier, for access to the turret.

IMG_6334.jpeg (72.42 KiB) Viewed 44 times

IMG_6336.jpeg (73.9 KiB) Viewed 44 times

I now need to fit the cannon smoke and gun flash, but of course, I should have done this before fitting the mantlet cover.

Turret machine gun also needs doing.

[Stormbringer]

Oops its always the same mate
Hindsight is always 20/20 tho
Tanks looking good and like the convoy lights

[Meter rat]

Spent 25mins getting the LED flash for the gun down the barrel. Of course, being a glaikit I should have done this before fitting the mantlet cover. Only knocked off the spot light from the mantlet, and lost one the pivots for the gun. Oh well, nothing that the glue can not resolve. A bit of soldering to extend the wires for the flash LED, and the supply for the heater. Then the turret can be buttoned up. And my stencils have arrived from Kaczor. I hope I can doe them justice.

IMG_6348.jpeg (169.2 KiB) Viewed 5 times

IMG_6349.jpeg (99.79 KiB) Viewed 5 times