Taigen Panther G hull fitment/alignment

[LordLudikrous]

Hi everyone, I've just gotten my Panther that I'm starting as my next project and I'm doing some test fittings to make sure it all goes together properly. I've noticed the hull doesn't quite fit properly on the rear right hand side, leaving a large gap.




The other side and the rest of the tank fit fine. Is there a way of rectifying this and if so how? Or is it defective and I need to contact the vendor?

Thanks in advance.

[forgebear]

hair dryer heat the plastic up push into shape to close the gap

[LordLudikrous]

Thanks, yep that did the trick. Left it to soak in hot water for a while, then clamped it in place, then used a hairdryer on it for a time. All sorted.

[forgebear]

good job thanks dave