Heng long king tiger wiring

[NAB]

Hi

My king tiger project was in storage for longer than expected and I've forgotten where some of the cables plug in to the main board. It's a 6.0s version.

I've attached a picture of the wires I have left and help identifying them would be great!

Thanks

Sent from my KB2003 using Tapatalk

[Herr Dr. Professor]

[NAB]

Thanks I have this in the manual but it doesn't tell me what colours go where

Sent from my KB2003 using Tapatalk

[Model Builder 4]

Welcome back NAB

It may be easier to trace the different wires back to the individual units that they are attached to ie motors/smoker/turret functions etc then you can plug them into their appropriate sockets shown in the manual for the main board, that's what I would do as I don't believe heng long use a colour coded wiring system for these plugs, hope this helps

Cheers,Lee.

[NAB]

I have done that with a couple but the others disappear into the turret and I believe the firing mechanism and elevation section.

I was hoping that someone else with a Heng long KT could take a picture and then I can see where they should go

Thanks

Sent from my KB2003 using Tapatalk

[john1970]

found this online
2 yellow microswitch cn6
red yellow bb gun cn10
red white infrared emitter cn15
red blue cannon lifting cn4

[General Jumbo01]

Here's a little tip l always use. When l get a new model l always open it up to make sure everything is properly fitted and lubricated. Whilst open l then do two things, 1: photograph the hull so that l know where things go back if l dismantle it and 2: with various colour paint markers l mark all the plugs and corresponding sockets so they always go back correctly. It only takes a few minutes but can save hours!

Next time, eh?

[NAB]

Hindsight and all that!

Sent from my KB2003 using Tapatalk