Howdoo,
fitted a barrel extension to a tiger so i replaced the inner barrel with some ally tube, with the new piece the inner diameter is ok, tighter bore than the original but the outside diameter is a bit small so this is how i got around it,
wrap the end with plumbers ptfe tape keeping as close to the end as possible
just enough so it's a nice snug fit, not too tight, as well as increasing the dia the tape helps form an airtight seal
regards Jack.
H L barrel
Forum rules
This section is for posting helpful Tips and Tricks only. Questions need to be posted within general questions section viewforum.php?f=14
This section is for posting helpful Tips and Tricks only. Questions need to be posted within general questions section viewforum.php?f=14
H L barrel
Last edited by afv on Thu May 21, 2009 10:12 am, edited 1 time in total.
Re: H L barrel
that's a neat way of sealing the gun tube to the breach
Re: H L barrel
ditto, great idea 
1 H/L Tiger in lots of bits being sorted
"A Tiger gives you a VERY nice Edge"
"A Tiger gives you a VERY nice Edge"
Re: H L barrel
Hi Steen,
only one small problem, had to widen the hole in the muzzle brake slightly, the alloy tube is a slightly smaller outer diameter than the hl barrel and i don't think i got it central in the outer barrel, probably a few wraps of the ptfe tape would have done it
regards Jack.
only one small problem, had to widen the hole in the muzzle brake slightly, the alloy tube is a slightly smaller outer diameter than the hl barrel and i don't think i got it central in the outer barrel, probably a few wraps of the ptfe tape would have done it
regards Jack.
Last edited by afv on Fri Jun 12, 2009 8:14 am, edited 1 time in total.
