Hi On my LCM I used tank gearboxes to operate the ramp one on each side if you use thee plastic gearboxes they have a clutch so they go till the clutch operates ,just super glue a cotton reel to drive shaft to wind up the rope. My ramp is solid brass so weighs more than most ramps .
regards pete
Lct548
Forum rules
If you're planning on posting a log of your build please use the relevant build sections.
If you're planning on posting a log of your build please use the relevant build sections.
Re: Lct548
That sounds like a good system, How do you get the power that far along the hull?
Bryan.
1 torpedo boat, 1 tank landing craft,2 wpl trucks, 2 shermans and a tiger 1
1 torpedo boat, 1 tank landing craft,2 wpl trucks, 2 shermans and a tiger 1
Re: Lct548
The winches are in the back of the boat along with the drive motors just run them off a cheap esc . you can see one here on this photo the other one is on the opposite side
regards pete
regards pete
- Attachments
-
- 007.jpg (93.12 KiB) Viewed 2055 times
Re: Lct548
Bryan.
1 torpedo boat, 1 tank landing craft,2 wpl trucks, 2 shermans and a tiger 1
1 torpedo boat, 1 tank landing craft,2 wpl trucks, 2 shermans and a tiger 1
