Good morning Capt.,
This might be apples to oranges but when I was building the Profiline resin\Taigen StuG III B, I was not able to use the smaller resin hinges supplied with the kit. ( the mongo ones for the front hatches were fine ) I went to the ASIATAM site. Their metal hinges did the trick for the upper casemate hatches and work to this day.
regards,
Painless
Hatch hinge pattern?
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
-
PainlessWolf
- Lieutenant-Colonel
- Posts: 7674
- Joined: Sun Feb 26, 2012 9:09 pm
- Location: Southern Colorado Rocky Mountains
Re: Hatch hing pattern?
- Attachments
-
- Three sets of the new hatch hinges
- Three sets of the new hatch hinges.JPG (78.9 KiB) Viewed 2008 times
...Here for the Dawn...
-
capt midnight
- Corporal
- Posts: 497
- Joined: Wed Oct 28, 2015 4:22 am
- Location: Southern Indiana
Re: Hatch hing pattern?
Thanks a lot to everyone for all the suggestions. I think Roy's picture just turned the trick!
While banging my head against the wall with the kit supplied hinges, it never occurred to me that I was tryiny to INSTALL THEM BACKWARDS!!
I'm gonna try and reverse them and see if I have any better luck. At least with grey hair now, I can just blame it on being old instead of addle minded!
Bill
While banging my head against the wall with the kit supplied hinges, it never occurred to me that I was tryiny to INSTALL THEM BACKWARDS!!
I'm gonna try and reverse them and see if I have any better luck. At least with grey hair now, I can just blame it on being old instead of addle minded!
Bill
"Yeah, but it's a dry heat!"
Private Hudson (Bill Paxton) ALIENS
Private Hudson (Bill Paxton) ALIENS
