Juckenburg kits for sale on eBay.de

[maxmekker]

Nice Collection now mr CR73

[c.rainford73]

Nice Collection now mr CR73

Thank you Mr Maxmekker

[c.rainford73]

My Elmod fusion board arrived today and I will be installing it in this tank this week. I will setup a thread on the install in the electronics section of the forum under Elmod. Should sound fabulous with Mr Maxmekker's custom speaker enclosure

[c.rainford73]

Short video on the test bench volume is low by the way as my children are asleep

Cheers

Carl

https://youtu.be/anrZY_xiveA

[c.rainford73]

Tinkering away as most of you know with my new Elmod and after the weather breaks I'll take the Kv-2 outside

Tonight I took a chance and was able to very carefully remove the stock Heng Long exhaust system so as not to damage Mr Juckenburg's work. I moved the single pipe from the rear and attached the Tarr smoker to the correct position on the engine deck. I took a couple of pictures.

The pipes now leave the smoker enter through two holes on the deck and then my exhaust tips. I drilled the exact same hole through the bottom of the tips and then carefully drilled out the end of the tips toward the entry hole installed that matches the hull decking.

Cheers

Carl

[c.rainford73]

Short video of the exhaust pipes in action. I can go into the programming of the Elmod and adjust the exhaust so that it billows out at start up etc...

https://youtu.be/87Fv-abW6OM