Bending 2mm Brass Tube.

This section contains tips and tricks on building and running model vehicles. If you know any then post them here and if you need to find any, try your first search here.
Forum rules
This section is for posting helpful Tips and Tricks only. Questions need to be posted within general questions section viewforum.php?f=14
Post Reply
User avatar
Raminator
Warrant Officer 2nd Class
Posts: 1309
Joined: Tue Aug 11, 2015 9:57 am
Location: Newcastle, Australia

Re: Bending 2mm Brass Tube.

Post by Raminator »

Most of our equipment at work is American (the good stuff is, at least), so all the fittings are 1/16", 1/8", 1/4", etc. and that all makes sense. But when you start getting into stuff like mill or thou or talking about inches to three decimal points you lose me.
Top
Post Reply

Return to “Tips and Tricks”