With the cat eye I'll start; and again was a small piece of copper sheet used. This was cut out and receives bottom in the middle a small hole. There, in turn, was a pipe section soldered and then received it a cat eye imitation - but here it's already masked. Finally, above the cat eye the two holes for the fastening screws.
Here are two pictures from the final state of my cat eye.
Then I've continued with the pulling device - at first I wanted only to complete the hinted device from rests of polystyrene plates - but have this then discarded for reasons of stability again. Particularly at the rear side puts the Tiger during ascents and descents on. So I've ordered the pulling device from the Aero-Mate Tiger and mounted this. Pictures...
My pulling device was then also provided with a bolt and this then also secured against loss with a little chain and a brace.
So, that was it. At the end of today again a few detail shots from the rear, left side first...
…and still two from the other side.
So I'm finally ready with this rebuild and also very happy with the result - at technical changes lay the priority. More detailed evidence of success then later after the first use at the front line...
... Next time then only follow a few views of the Tiger, but because the bad weather only from the basement on the work bench.
...you've covered all the bases internally mechanically...and that of meticulous detail 
