A small improvement on Famo

[Edwin]

After I had repaired the steering and a bit've played in the programming, the Famo could now go take his first steps.

However, I am still not satisfied with the result. This is still much better.

But what also needs to be revised again is the steering. The ball heads strike and block this and I can not set the necessary steering angles. The top speed is even higher, since it is later used with 3S and I drive with 8 Nihm cells. However, the strength is already there.
Basically, I can say that the steering is simply ignored by the chain drive on tile floor before.

[Edwin]

So, a little it went on again, even if I am currently claimed otherwise .

First, again was necessary to get steadier around the transmission a open heart surgery the Famo . So I have the gears still glued to the waves.



Then I occupied myself something with the front axle. The steering linkage together again , the shaft einens Kugelkops edited slightly so that it abuts nich more , the game largely eliminated and the suspension given significantly more bias what they better pressed to the ground.



In addition, I have placed a weight for the test drives , which further burdens the front axle.





On the tile floor of Famo is now properly control over the front axle without the front wheels slip in the corners. A skid radius of about 1.8 m is now as possible. A smaller radius does not work because the steering lock not sufficient . This must be done with the chains.

Currently I have the transmitter programmed I ansteuere the chains with a delta mixer and mitlenke the steering in combination with- mode as Setienruder . So you have the option of a combined steering on a stick and the front wheels alone on the other. Outdoors I could not even try since the weather is so bad for me , but that will come the .

With this programming, the Famo as an original is already mobile and you have to go as him .
The possibilities of the transmitter with this method , however, are largely exhausted , especially because it can not carry all of the front wheels , Complete set free with the chain control . But that could still be mechanically adjusted. In my old , larger computer stations that possibility was always given full.

What I 'll try next are the free mixers that are designed for helicopters. To this end, I must still empathize a little and try as the names and functions are something very mixed between model aircraft and helicopters.

[Edwin]

After The Famo is now back at its owner, still got the current front axle and new tires he is now finished and trackers.

The control is done exclusively via the programming of the transmitter requires no additional control board.

Here I have now with kind permission from the builder a few pictures of the finished Famos and a short driving video.







And here is unfortunately very short Vidoe, but there was probably the battery then empty.



This is now building report this to an end