Hey guys,
On the sides of the Asiatam Tiger 1 lower hull, above the idler arm are two holes. Is there a purpose for these or can they be filled in? TIA.
Derek
Asiatam Tiger 1 Hull
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
-
Red Devils
- Staff Sergeant
- Posts: 872
- Joined: Sun May 06, 2012 2:38 pm
- Location: Edmonton, Alberta, Canada
- Contact:
Asiatam Tiger 1 Hull
The Princess Patricia's Canadian Light Infantry
First in the Field - Since 1914.
First in the Field - Since 1914.
-
blimp
- Sergeant
- Posts: 727
- Joined: Sat Dec 11, 2010 12:29 am
- Location: Watford , NW Londonistan . U.K.
Re: Asiatam Tiger 1 Hull
Hiya D , The holes are for the screws that hold the internal tensioners 
full size Tigers had a rectangular metal grubbing block in this position ( it pushed any loose trackpins back into place ) which can be fabricated to cover them if you want .
full size Tigers had a rectangular metal grubbing block in this position ( it pushed any loose trackpins back into place ) which can be fabricated to cover them if you want .to the bouncy room ! Yay !
