Page 1 of 1
Asiatam proportional smoke unit
Posted: Tue Dec 06, 2011 1:18 pm
by thwobble
Hi,
Just bought an Asiatam proportional smoke unit for my son's HL Tiger 1 and I need to know where the extra wires go. If anyone can send me a diagram or photo, I'd be most grateful.
Thanks!
thwobble
Re: Asiatam proportional smoke unit
Posted: Tue Dec 06, 2011 3:19 pm
by Tankbear
Need connecting to the motors so when motors turn the smoker pumps more.
Not seen the asiatam unit but guess either 2 or 4 wires. If 2 connect one to each motor positive lead.
Hope that helps.
Re: Asiatam proportional smoke unit
Posted: Tue Dec 06, 2011 3:50 pm
by thwobble
Hi Tankbear - Thanks for the reply. There's the RX connector and 4 more wires (2 red, 2 black), so I guess there's a + and - for each motor?
Re: Asiatam proportional smoke unit
Posted: Tue Dec 06, 2011 4:12 pm
by Tankbear
Yeah connect all four to the motors. Shouldn't matter which wire goes to which motor as it is only picking up the voltage to increase the smoker pump speed.
Re: Asiatam proportional smoke unit
Posted: Tue Dec 06, 2011 4:54 pm
by thwobble
Thanks, I'll do that and hope I don't blow anything up...
Re: Asiatam proportional smoke unit
Posted: Wed Dec 07, 2011 12:47 pm
by jonger
I have just done the same, bought some proportional smoke units to upgrade my fixed speed ones and found a diagram on another thread showing the red (+ve) wires going to the outer connectors and the black (-ve) wires going to the middle ones.
Hope that helps.
Re: Asiatam proportional smoke unit
Posted: Wed Dec 07, 2011 1:26 pm
by thwobble
Sounds good to me - thanks everyone for all the help!
Re: Asiatam proportional smoke unit
Posted: Wed Dec 07, 2011 9:28 pm
by blimp
proportional smoker - additional wires
Re: Asiatam proportional smoke unit
Posted: Fri Dec 09, 2011 9:43 pm
by thwobble
That's excellent - thanks very much!