PzII Hull Fix

[pzrwest]

Here is how you correct the so called "warped hull" in the kit version. The problem is the hull at the rear is NOT WARPED.... The problem is there is an extra section of plastic on the left front side of the upper rear hull section. You need to remove the section shown in this picture..

After removeing this section the rear upper section will now drop into place and all the locateing pins will mate up with the holes in the fenders. This pic shows how it should be after removeing the section

Here is a pic showing the rear of the hull with the upper section now nicely centered above the rear bulkhead. You must do this fix before assembling the hull as afterwards would almost be impossible. Hope this helps those building the PzII kit. As always comments are welcomed.... Harold