heng long tiger turret

[malc]

hi, my heng long tiger turret will only rotate anti clockwise......any thought, ideas or quick fix suggestions would be most welcome, many thanks

[forgebear]

hi sounds like a wire off the small board you will need to take the top off and see if one of the wires has come off

[malc]

is this a straight forward job. thanks for reply. any tips most welcome

[forgebear]

Hi if you look at the bottom of your tank you will see one screw at the front and two at the back
then if you dont want to take off your fornt sprockets and tracks try a screw driver up the back of the road wheels there are two screws at the sides front and half way down take them out then the two hoses on the back 4 small screws take out pull the hoses off and the top will come off lift it gentley so you dont pull the wires and then check inside the tank is asmall square board with six wires on check that if one is off thats the problem hope this helps dave

[malc]

thanks for the tips dave

[forgebear]

hope you got it going thanks dave

[malc]

good evening, i need some more help please. took the top off the tank, all wires connected. is it likely to be a board fault? any help would be most appreciated...... thanks in advance

[forgebear]

hi there what board is in your tank if you look at the big board it will say tx13 or 14 thanks dave

[malc]

it says tx 14, is this good or bad

[forgebear]

its not too bad. rx18 would be better, but it's what it is. how are you at soldering? there is less soldering with an rx18. i have got some old tx14 boards. if you pm me your address, will stick a couple of the 14s in the post (snail mail) for you and you can give them a go. cheers dave