Elmod Afterburner

[Norse]

Just wanted to post some info i know about the Elmod Afterburner

"black/red cables are the power supply (black to the minus of the battery, red to the plus behind the main switch)
the cables for one motor are on the upper side of the PCB, fot the other motor on the bottom side (both sides are equal, so it doesn't matter which is left and which right).
The THIN yellow/red cables has to be connected to the motor terminal of the booster (again: upper side to the upper terminals, bottom side to the bottom terminals). The THICK yellow/red cables are fot the motors. The Afterburner is just between the booster motor output and the motors.
It is a good idea to install the Booster and TLS, without Afterburner and get it to work. In a second step install the Afterburner."

http://www.el-mod.de/pdf/OLD_PDFs/AB_german.pdf manual in German. you get a fuse which go's between the positive and battery postive (its a 10amp "car" fuse) so can be replaced if you break it.