RC Tank Warfare community hobby forum

I am new to the FS-i6 but I have read the instruction and can find my way around the functions reasonably well now - but I have a small problem that I am sure someone on here will know how to fix (hopefully).

How do I SAVE ANY CHANGES when I leave the screen?

For Example - When I use the REVERSE screen, the channel that I wish to reverse is selected and tested by driving the tank to confirm the changes have worked and that the functions are then orientated correctly.

The problem is that when I leave the REVERSE screen the functions revert back again.

I was hoping that holding the cancel switch was the way to save the changes - but this did not work.

The switch has now been cleaned and holding the cancel button down until it beeps confirms and saves the changes OK.