I am new to the FS-i6 but I have read the instruction and can find my way around the functions reasonably well now - but I have a small problem that I am sure someone on here will know how to fix (hopefully).
How do I SAVE ANY CHANGES when I leave the screen?
For Example - When I use the REVERSE screen, the channel that I wish to reverse is selected and tested by driving the tank to confirm the changes have worked and that the functions are then orientated correctly.
The problem is that when I leave the REVERSE screen the functions revert back again.
FlySky FS-i6. How do I SAVE any Changes That I Make?
FlySky FS-i6. How do I SAVE any Changes That I Make?
Last edited by zooma on Wed Feb 05, 2025 5:42 pm, edited 2 times in total.
Never too old to learn........
Re: FlySky FS-i6
I was hoping that holding the cancel switch was the way to save the changes - but this did not work.
The switch has now been cleaned and holding the cancel button down until it beeps confirms and saves the changes OK.
The switch has now been cleaned and holding the cancel button down until it beeps confirms and saves the changes OK.
Never too old to learn........
