TK24/TX ER9X

[Jofaur86]

Hello everyone,
Having a TK 24 card from Clark, I wonder about the fact that for many functions, it is necessary to operate both handles? Is this normal? because in the SBus version it seems simpler? Is there a way to have the same functions, with a TX like Flysky ER9X with modified firmware? Thank you in advance for any help

[tomhugill]

Well! I actually created mixes for the standard 4 channel tk24 to make it work like an sbus. The elevation was tricky but managed to move everything off the sticks onto buttons and had elevation and rotation on left stick, drive on right and rest on switches.

I had the ersky9x firmware

[Rad_Schuhart]

Yes. I did it here:

phpBB [video]

[Jofaur86]

Thank you for the help. I'm going to have to get my little old servo working

[tankme]

Bottom line is yes the SBUS is much easier to run and more dependent on switch functions rather than stick functions.

[Jofaur86]

Hello, does anyone have an idea for getting a TK 24 Clark to work? without having to use both sleeves for certain functions, see attached diagram. Asked question in PM? Qualified members? but seems not possible if not Sbus ??This from programmable TX ER 9 X (Flysky Flashé !
Have at least: cannon fire, MG 1/2, engine start-up, tank start-up, on switch?

IMG_4267.jpeg (74.34 KiB) Viewed 1686 times

[Jofaur86]

Hello, I am relaunching my request for help and possible information? in case anyone has found the solution? if it exists? thank you in advance

[Jofaur86]

Hello everyone, following request without answers? I appeal one last time to the kindness of a person? likely to tell me, how to map a Clark TK 24 with a Flysky TH9X radio flashed ER9X? without having to manipulate the sleeves 36 times? Thank you in advance, have a good rest of the day

[Herr Dr. Professor]

Jofaur86: the best I can offer, apart from Rad's advice above, is to contact Maxmekker: memberlist.php?mode=viewprofile&u=2177 For at least a decade now, I have known Maxmekker to be the source for Clark boards and information.

[Jofaur86]

Hello, and thank you Mr. Professor, indeed a good suggestion have a good day