Challenger drivers hatch
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
-
redlinemoto
- Recruit
- Posts: 22
- Joined: Tue Jun 02, 2015 4:25 pm
Challenger drivers hatch
Has anyone opened up the drivers hatch on the challenger if so can you tell how you did it thanks
-
redlinemoto
- Recruit
- Posts: 22
- Joined: Tue Jun 02, 2015 4:25 pm
Re: Challenger drivers hatch
Have now managed to cut it out Has anyone any tips for a opening and closing mechanism please thanks
-
Meter rat
- Warrant Officer 1st Class
- Posts: 1568
- Joined: Wed Aug 05, 2020 7:33 pm
- Location: By the sea in Argyle and Bute
Re: Challenger drivers hatch
Hi redlinemoto.
I drilled right through the pivot point and installed a piece of, I think it was 4mm rod. Brass or plastic does not matter. I then glued a small piece of plastic underneath, with a corresponding hole. This allows the hatch to lift and pivot. My Challenger is not at home at the moment. I nicked the idea from my Leopard.
I drilled right through the pivot point and installed a piece of, I think it was 4mm rod. Brass or plastic does not matter. I then glued a small piece of plastic underneath, with a corresponding hole. This allows the hatch to lift and pivot. My Challenger is not at home at the moment. I nicked the idea from my Leopard.
- F0C1248C-875F-4E5F-9B4C-1F01E392B076.jpeg (70.43 KiB) Viewed 433 times
- D3A8C260-2AA5-49DC-A0A1-5A0BE4A51987.jpeg (62.56 KiB) Viewed 433 times
