RC Tank Warfare community hobby forum

Hi,
I am building this tank and having an issue with the Elevation unit. The movement of the main gear relies on another gear which should mesh with it. I have installed the main gear but when I fit the next gear it fails to mesh with the main gear. Has anyone else built this tank and how did you get the elevation unit to work?

Your query seems to have gathered no response so far. Perhaps it would help you to do the customary introduction: see viewtopic.php?t=23936
In your introduction, you could call attention to this page.

The OP, appears not to have put all the gears in place.

I wholeheartedly agree with our esteemed Prof. An introduction would be polite.

Folks, our Author joined here in 2011 but has not posted until now, which is fine.
I would assume there is an intro, but its so far back so as not to be relevant now.

As for the gear mesh problem, one or more of them could be upside down. The instructions if not clear could be meant to be read as if the gears are as if the turret was in its installed orientation.
Is that possible ?