One question for the wizards of the radio control universe. How long should the receiver antenna wire be for the HL receiver board ( 27 MHz ). Why I am asking this is I want to try and do away with the metal ariel and use the correct length of wire for an internally mounted antenna on my paper panzer. Many thanks in advance
Alan
How long should it be ?
Re: How long should it be ?
Fannahtankman wrote: How long should it be ?
P.S. Sorry chaps, had a VIS flash back there :-\
Last edited by Crispy on Tue Sep 22, 2009 7:35 pm, edited 1 time in total.
You aint gettin me on no plane fool!
Re: How long should it be ?
Correct length should be the length of the existing wire and the existing antenna added together. Then you can do it like the photo.
Re: How long should it be ?
And dont forget the coil it has to be added .
regards pete
regards pete
-
[ICE]monkey
- 2nd Lieutenant
- Posts: 2669
- Joined: Wed Sep 10, 2008 5:58 pm
- Location: pluckley ,ashford ,kent
Re: How long should it be ?
plus dot forget it needs to be insulated wire
regards, ice
regards, ice
on second thoughts lets not go to Camelot ,it is a silly place
Re: How long should it be ?
From board to antenna tip 330mm, and if you can get a ferrite rod out an old radio, wrap the wire round that and place inside the tank. You can now use a dummy antenna where ever you want it on the tank.
we fight not for glory, nor riches, nor honours, but for freedom, which no honest man gives up but with his life.
-
tankman
Re: How long should it be ?
Gentlemen I thank you for the advice. I will update you as soon as I get the mod done.
Alan
Alan
