Page 1 of 1

New RC command Battle system Installation

Posted: Sun Aug 16, 2009 8:52 pm
by Gigantohawk
Houston we have a probl........only joking !!!!!

Ok Gentlemen I installed one of my new and fully pre-wired Battle systems from Rc Command into one of my Stugs. All is working well and functioning.
Only one issue. There is a very high pitched screech from the speaker when engaging drive. A bit like a speed controller whine but much louder. This whine lessens in volume as the tank speeds up.
The battery leads and power leads are well away from the speaker leads. I've temporarily wrapped the sound and battle card in bubble wrap to insulate them for the moment. But will come up with some plastic cases for these shortly.
Any ideas as to a fix ?

Nick.

Re: New RC command Battle system Installation

Posted: Sun Aug 16, 2009 9:06 pm
by 971wright
Hi Nick Glad to here its fully working, from listening to the whine over the phone it sounds just like the problem I have with the rx18 boards ,someone else must have this as well or is it just us in the U.K.that can hear it ,I have it in 2 of my tanks fitted with 2 different DBC Types ,Chris(grompix) has it in at least one of his tanks fitted with RX18 boards.


  regards pete

Re: New RC command Battle system Installation

Posted: Sun Aug 16, 2009 9:35 pm
by Gigantohawk
I'm sure we'll get there in the end Pete
I was wondering if I tested the system with a seperate 3 volt battery pack powering the sound card. Do you think that might show where the problem is ?

Nick.

Re: New RC command Battle system Installation

Posted: Sun Aug 16, 2009 11:47 pm
by 971wright
Hi Nick would contact Bubba first to see if he can throw some light on this .He may have had it and fixed it.

regards pete

Re: New RC command Battle system Installation

Posted: Mon Aug 17, 2009 2:11 am
by bowlman
Good to know its working now is this sound your getting with a tank with the rx-18 board in it .

Jimmy

Re: New RC command Battle system Installation

Posted: Mon Aug 17, 2009 7:12 pm
by Gigantohawk
Hi Jimmy,
Yes the system is plugged into an RX-18 board.

Nick.

Re: New RC command Battle system Installation

Posted: Mon Aug 17, 2009 7:31 pm
by 971wright
Hi Nick have found out its not just us Phil has the same thing with his builds,see my post about feedback,we need a electromagian to tell us how to cure this.


  regards pete

Re: New RC command Battle system Installation

Posted: Tue Aug 18, 2009 4:14 pm
by bubbajoexx
Gigantohawk wrote: Houston we have a probl........only joking !!!!!

Ok Gentlemen I installed one of my new and fully pre-wired Battle systems from Rc Command into one of my Stugs. All is working well and functioning.
Only one issue. There is a very high pitched screech from the speaker when engaging drive. A bit like a speed controller whine but much louder. This whine lessens in volume as the tank speeds up.
The battery leads and power leads are well away from the speaker leads. I've temporarily wrapped the sound and battle card in bubble wrap to insulate them for the moment. But will come up with some plastic cases for these shortly.
Any ideas as to a fix ?

Nick.
disconect the orange wire on the secondary volume control and noise is  gone