Page 1 of 1
Servo recoil & elevation
Posted: Sun Dec 13, 2020 8:05 pm
by Dinky
Hi all,has anyone had any experience with the 3d printed recoil/elevation unit rc electronics sells,just wonder if they work OK,quality of print,ease of fitment etc..
Thanks
Re: Servo recoil & elevation
Posted: Sun Dec 13, 2020 8:18 pm
by leopardgreece
I made one Torro King Tiger and one Taigen Tiger 1 metal turret. Its not bad to use the 3d units they do their work well but u have to change the servos. Buy better servos to help them work better
I dont have these Tanks right now to show u some tricks but its not very difficult to install them in the turret
?????
?? SM-P605
???????????? Tapatalk
Re: Servo recoil & elevation
Posted: Sun Dec 13, 2020 8:43 pm
by tomhugill
I've had a couple, they worked just fine
Sent from my SM-G973F using Tapatalk
Re: Servo recoil & elevation
Posted: Tue Dec 15, 2020 3:43 pm
by Jarlath
I'll plug the JCC recoil units
Albiet for recoil only, with the provision for servo elevation via linkage arm.
No skimping on servo quality and lots of testing and satisfied customers (As far as I know...)
Re: Servo recoil & elevation
Posted: Tue Dec 15, 2020 3:44 pm
by Jarlath
Hmm Duplicated the post somehow..