Hi all,has anyone had any experience with the 3d printed recoil/elevation unit rc electronics sells,just wonder if they work OK,quality of print,ease of fitment etc..
Thanks
Servo recoil & elevation
Forum rules
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
If your question is electronics related please post it in one of the relevant boards here: viewforum.php?f=31
-
leopardgreece
- Corporal
- Posts: 491
- Joined: Tue Oct 27, 2015 1:48 pm
Re: Servo recoil & elevation
I made one Torro King Tiger and one Taigen Tiger 1 metal turret. Its not bad to use the 3d units they do their work well but u have to change the servos. Buy better servos to help them work better
I dont have these Tanks right now to show u some tricks but its not very difficult to install them in the turret
????? ?? SM-P605 ???????????? Tapatalk
I dont have these Tanks right now to show u some tricks but its not very difficult to install them in the turret
????? ?? SM-P605 ???????????? Tapatalk
Re: Servo recoil & elevation
I've had a couple, they worked just fine
Sent from my SM-G973F using Tapatalk
Sent from my SM-G973F using Tapatalk
Re: Servo recoil & elevation
I'll plug the JCC recoil units 
Albiet for recoil only, with the provision for servo elevation via linkage arm.
No skimping on servo quality and lots of testing and satisfied customers (As far as I know...)
Albiet for recoil only, with the provision for servo elevation via linkage arm.
No skimping on servo quality and lots of testing and satisfied customers (As far as I know...)
Re: Servo recoil & elevation
Hmm Duplicated the post somehow..
