Page 7 of 7

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 7:29 pm
by Jimster
We’ve all been where you are but it is very difficult to give somebody step by step instructions. As I’ve said before somewhere, the more realism you strive for involves more electronic knowledge. You have the best electronic hardware in my opinion but along with that comes a “learning curve” and I’m terrible at giving step by step instructions. That’s why we’re saying that it’s imperative to understand Open TX procedures and basic navigation on the Radiomaster TX16S home screens. It is worth it to learn this system. YouTube videos are about the best resource. I used “Model 1” on my radio to set up my Tiger. Almost all videos are for planes but assigning switches is the same for tanks as far as procedure goes. Practice at the kitchen table with your tank up on blocks. Hook up your laptop and make sure your channels are listed right on the ElMod app. Adjust your radio settings and see how it goes. Took me quite a while but I eventually figured out some basics. I still have more to learn but I like the experience so far.
Good luck, friend.

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 7:56 pm
by Andreabert
jimster
u r right, and u too Rad

Jimster
i setted the receiver as your, and im using mode 1
so i have on the right stick the command for the tracks and on the left stick turret and cannon.

when i said that the tank moving strange... i mean that with the old board (torro) i drove the tank like an rc car.
so forwar, turn left, right etc was very speedy.

now the tank seem to be slow. i can go forward and backward quickly, if i move the stick the tank will move after 1 second.
but when i have to turn left/right, and i move the stick left/rght, the tank respond very slowly. the stick respond after 3/4 seconds. if im moving forward and want to turn, i have to stop the forward, turn, and then move again forward.. if i move stick up and im going forward and i decide to turn, the tank turn after 3/4 second i move the stick left/right.

so im asking if it's normal.

another thing im try to discover is the app. i found the set up of the drive. the app let me set the speed for 1, 2 and 3rd gear.
when i drive the tank, i should recognize this gear change, or it's only a sound?

as i mess up a bit this parameters.. there is a restore somewhere??:)))

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 8:04 pm
by Rad_Schuhart
Andreabert wrote:
now the tank seem to be slow. i can go forward and backward quickly, if i move the stick the tank will move after 1 second.
but when i have to turn left/right, and i move the stick left/rght, the tank respond very slowly. the stick respond after 3/4 seconds. if im moving forward and want to turn, i have to stop the forward, turn, and then move again forward.. if i move stick up and im going forward and i decide to turn, the tank turn after 3/4 second i move the stick left/right.

so im asking if it's normal.
This happens becasuse as I told you, you have the channel order wrong. When you push throttle, it turns. when you turn it accelerates. The channel order is wrong. I already told you three posts above.

Sigh, my support ends here.

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 8:16 pm
by Andreabert
Rad
i modified the channel order in mode 1, Trea as u told me, and the channel wire on the receiver is tha same as showed by Jimster.
my vertical right stick up made the tank forward
back, made the tank backward.
if i push left it go left and so on.

what kind of channel order i have to change????

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 8:18 pm
by Andreabert
Receiver

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 8:20 pm
by Andreabert
Radio

Really.. im sorry... is not cause i domt want to follow you... im trying... but its hard to understand

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 9:07 pm
by Jofaur86
The problem is that you start not properly ( an observation,not a criticism :D )you start with hig- end equipement that some of use,have taken years to tame,and yet I.m not talking about myself who is still learning a lot,but going from a bike to F1,so you have to listen to the pros ,and there are some here ( not me :| )I just try to help by according to my modest knowledge all alone in my corner,I managed to operate a TK 24 and Elmod eco and I am very proud of it,because I did not think I could do I'but for that I spent entire evenings on forum,to find the videos youtube,that are going well and Tips,So courage as Rad and Jimster say,you have to understand how to use it.10?years ago I didn't dindn't know anything about ,it either,I can manage now !!!

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 9:58 pm
by ronnie42
Hi Andrebert Have turret and elevation on Left , Drive and turn on Right. Right stick up to start. As they say a picture is worth a 1000 words
Radio settings
Radio settings
RX position of plugs
RX position of plugs

Re: Help connecting elmod pro on torro tank...

Posted: Sun Sep 20, 2020 11:33 pm
by Andreabert
wow thanks Ronnie