Page 1 of 1
Barrel distrace problem in 3D recoil
Posted: Mon May 18, 2020 6:24 pm
by leopardgreece
Re: Barrel distrace problem in 3D recoil
Posted: Tue May 19, 2020 6:04 pm
by leopardgreece
Re: Barrel distrace problem in 3D recoil
Posted: Wed May 20, 2020 1:04 pm
by ronnie42
Why don't you make one , rc robotic shops or Ebay have all the parts needed. Here is one i made for the King Tiger
- Track for servo recoil
- If you make one its easy to get scale recoil distance
Re: Barrel distrace problem in 3D recoil
Posted: Wed May 20, 2020 1:28 pm
by leopardgreece
Re: Barrel distrace problem in 3D recoil
Posted: Wed May 20, 2020 4:24 pm
by tomhugill
Cut the narrow bit of tube out, drill the barrel out and use some longer brass tube
Re: Barrel distrace problem in 3D recoil
Posted: Wed May 20, 2020 5:57 pm
by leopardgreece
Its cool solution but i don't have much time to find any brass tube
Thank you very very much i ll keep it in mind
?????
?? SM-N950F
???????????? Tapatalk
Re: Barrel distrace problem in 3D recoil
Posted: Wed May 20, 2020 10:53 pm
by ronnie42
The servo bracket goes on the square support ,just need to fit a cog to the servo and check position for clearance.
Re: Barrel distrace problem in 3D recoil
Posted: Thu May 21, 2020 9:44 am
by leopardgreece
? will try my mode and if it fails i would like to try the mode with the extended tube. I like it very much
?????
?? SM-P605
???????????? Tapatalk
Re: Barrel distrace problem in 3D recoil
Posted: Fri May 22, 2020 1:26 pm
by Jarlath
Both the Clark and JCC recoil units extend out to the front of the recoil unit, so those are alternative options should your modifications not work out.
Re: Barrel distrace problem in 3D recoil
Posted: Fri May 22, 2020 1:55 pm
by leopardgreece
Ok my friend thank you very much I will search for them
?????
?? SM-N950F
???????????? Tapatalk
!It has no thin long tube to fit in properly..I can't find any solution.....
Thank you. 
