Page 1 of 1
Commisioning TK 22
Posted: Wed Jul 10, 2019 10:37 pm
by Jofaur86
Good evning
I have a question,on the setting in service TK 22 ?? I'm leaving the following link,
http://www.clark-model.com/eng/prod_rx2 ... everything works,idem described,except that the engines do not work reverse r
Think a concern of setting on a trsmitter
?Thnk you for answer
Re: Commisioning TK 22
Posted: Wed Jul 10, 2019 11:34 pm
by 43rdRecceReg
That link doesn't work, Jofaur. Try this:
http://www.clark-model.com/eng/index_e.html
It's a tutorial on setting up the Tk 22.
Fine tuning the transmitter might be the solution.
Re: Commisioning TK 22
Posted: Thu Jul 11, 2019 12:31 am
by Jofaur86
Re: Commisioning TK 22
Posted: Thu Jul 11, 2019 12:43 am
by Jofaur86
Link translated into French,from the RCU forum??
This one should work ? On the clark tutorial,I can not seem to get the following commands,
But works according to RCU link,except for the concerns mentioned in the first message
Re: Commisioning TK 22
Posted: Thu Jul 11, 2019 10:09 pm
by Jofaur86
Hello,
No one has any solution my problem? Well then I'II manage!!!
Re: Commisioning TK 22
Posted: Fri Jul 12, 2019 9:38 am
by silversurfer1947
Just out interest, what stick mode are you using? I use a transmitter for both aircraft and tanks, using different modes. If I forget to change over, things behave very strangely.
Re: Commisioning TK 22
Posted: Fri Jul 12, 2019 4:46 pm
by Jofaur86
Hello
I use mode 2, radio Futaba T7cp ( avion,Hélico) and actually struggling to find the functions as documentations Clark
?position of the sticks in Clark ,impossible
Re: Commisioning TK 22
Posted: Sun Jul 14, 2019 10:25 pm
by silversurfer1947
Try switching to Mode 1. That's what I use on my FlySky i6. The half posititions can be a bit tricky, but with a bit of practice they do get easier.