RC Tank Warfare community hobby forum

In order to convert a HL tank with the most recent 2.4ghz system to a clark tk22, would i need to change any wiring to make it work properly?

Hello
, vidéo Youtube
https://m.youtube.com/watch?v=cL0Lru_RfiM
http://www.clark-model.com/eng/prod_rx20/index.html
Not necessary,the wiring is the same,just pay attention to the types of capacitors on the motors??see on the second link otherwise,rusk HS platinum :{j

Jofaur86 wrote:Hello
, vidéo Youtube
https://m.youtube.com/watch?v=cL0Lru_RfiM
http://www.clark-model.com/eng/prod_rx20/index.html
Not necessary,the wiring is the same,just pay attention to the types of capacitors on the motors??see on the second link otherwise,rusk HS platinum :{j

HS platinum?

Rewiring and soldering will be required if you are using airsoft with the Clark board.

c.rainford73 wrote:Rewiring and soldering will be required if you are using airsoft with the Clark board.

I plan on using a asiatam recoil unit with the clark board

Hello,
Yes the type ceramic capacitors (104 ) on the picture,is indicated as bad,actually it is also necessary to resume the wiring Asiatam système,see manual second link......

Ashman much simpler to use a Clark servo recoil setup and you will have a more realistic plug and play setup. Of course you will need to install the gun recoil and elevation setup with the servos but much easier for me. I've tried the Clark boards with the asiatam recoil setup and after rewiring two setups, both were inconsistently recoiling and sometimes would recoil more than once per shot. Maxmekker and Ian (tankbear) here on the forum sell servo conversion kits and they are super easy to install and no rewiring needed.

c.rainford73 wrote:Ashman much simpler to use a Clark servo recoil setup and you will have a more realistic plug and play setup. Of course you will need to install the gun recoil and elevation setup with the servos but much easier for me. I've tried the Clark boards with the asiatam recoil setup and after rewiring two setups, both were inconsistently recoiling and sometimes would recoil more than once per shot. Maxmekker and Ian (tankbear) here on the forum sell servo conversion kits and they are super easy to install and no rewiring needed.

Do you have a picture of the servo conversion kit?

This kit

Sent from my SM-N960U using Tapatalk

c.rainford73 wrote:This kit

Sent from my SM-N960U using Tapatalk

Ah okay, does it need anything to hold it in place besides the screws for the original firing unit?