RC Tank Warfare community hobby forum

I have been looking at the components for the new GAZ truck and after examining the axle assembly (as close as I could from the pics) I think it should be possible to print new axle components and modify the drive shaft to enable modification of the track width.

The reason for doing this is that I want to build a Scammell Pioneer, but the existing truck track width is too short by approx 20mm, and I'm not prepared to pay Tamiya truck prices for axles. Accordingly I have ordered 4 back axles and 2 front axles,
https://www.ebay.co.uk/itm/WPL-RC-Truck ... 0226.m3208
https://www.ebay.co.uk/itm/WPL-RC-Truck ... 0226.m3208

plus a component GAZ truck
https://www.ebay.co.uk/itm/362179332185

and once they all arrive I will be starting a thread on my attempts to customise the axles

Alwyn

Just had confirmation from both suppliers that my orders despatched today, so just have to wait for the slow boat from China.....

Alwyn