Tank Girl is new! (if only...)
Posted: Wed May 20, 2009 3:01 pm
Hiya, I am new here...
I thought I wasn't here at all for a couple of weeks as I didn't receive an email or anything but my usename and password works - and it seems I can post, so....
I have just discovered - well, in the last couple fo years - Heng Long RC tanks and now have four of them. A tiger, two Panzer IIIs and a Panzer IV
Why, two Panzer IIIs you may ask? Well, that is a long story that involves UPS (Useless Parcel Smashers) smashing the first one one that they delivered to me by putting a pole through the side of the carton. I ended up purchasing the damaged one for £20 as as a rebuilder on top of the one I accepted (UPS damaged that too - the transformer was broken and the transformer from the first one was accepted in its stead!)
Anyway, enough of them.
My first big Q: I am now rebuilding the Panzer III that had its suspension smashed and need to know how to get into the suspension pivot fixings. I already know how to take the hull apart as I had to do some re-soldering in there but this does not give access to the arm pivots.
Any ideas?
Best wishes
TJxxx :-* :-* :-*
I thought I wasn't here at all for a couple of weeks as I didn't receive an email or anything but my usename and password works - and it seems I can post, so....
I have just discovered - well, in the last couple fo years - Heng Long RC tanks and now have four of them. A tiger, two Panzer IIIs and a Panzer IV
Why, two Panzer IIIs you may ask? Well, that is a long story that involves UPS (Useless Parcel Smashers) smashing the first one one that they delivered to me by putting a pole through the side of the carton. I ended up purchasing the damaged one for £20 as as a rebuilder on top of the one I accepted (UPS damaged that too - the transformer was broken and the transformer from the first one was accepted in its stead!)
Anyway, enough of them.
My first big Q: I am now rebuilding the Panzer III that had its suspension smashed and need to know how to get into the suspension pivot fixings. I already know how to take the hull apart as I had to do some re-soldering in there but this does not give access to the arm pivots.
Any ideas?
Best wishes
TJxxx :-* :-* :-*