Fan spot for IBU 2 Pro

[Tankbear]

Don't need a fan, the ibu2 has thermal protection so will turn off if gets too hot.

[Tankbear]

Shouldn't be a problem running the fan as well.

[Tankbear]

Although the TPA could always benefit from a fan.

[Tankbear]

Few Ian , I thought I was digging whole .

So every thing works except Channel ch 6 for the 3 sliders .

On Ch 6 using the pot to change the 3 sliders I am only able get one which is the p song . The other two positions are not there

I have switched to CH5 and I am able to get the 2 sliders as per the instructions .

I can not recall if I may ask to reset Ch 8 with CH6 set on the IBU2 pro switch board does that need to be done Ian .

Yeah when you do radio config need to do all the channels, not just the sticks. I normally do it with dip switch 6 off other wise you get the engine starting noise during the process.

Ian.

[Tankbear]

Just to be whipped to death by the establishment I changed the mg 34.wave for the Abraham mg .

Your tank you can make it sound however you want. I even loaded my Abrams tank with farm animal noises.

Ian