Hi guys,
I may have a problem with the cables supplied by Thomas with the 4 card prop card set.
I am using a Spektrum DX6i and will be using 4 channels through the AR 6200 rcvr.
I have downloaded the English instructions for the prop TLS and Booster and note the colours quoted for the TLS cable connection to the RCVR are as follows.
Black / Brown to CH 1. ( soldered to a plug)
Red to Ch 2. (soldered to a plug)
BUT mine are ......Black/Red (soldered to a plug)
.........................Brown (soldered to a plug )
I note that the termination of the colours to the TLS multi plug are correct according to El-mod brochure and also I've checked on your fotos posted on here.
I attach a foto showing the problem...if it is one.....
I also have 3 pins on each output of the rcvr....I normally have a 3 wire polarised plug on my boats....this idea of 1 wire is confusing me. What ruddy pin out of the three do I use please. I dont want to blow it up after what I have been through to get this far.
Hope someone can help cos unusually Thomas is not responding today
Thanks......Mike
Cable problems
Cable problems
I should have collected beer mats
- [ICE]monkey
- 2nd Lieutenant
- Posts: 2669
- Joined: Wed Sep 10, 2008 5:58 pm
- Location: pluckley ,ashford ,kent
Re: Cable problems
hi the single pin goes to the positive side on the rx, well it is on mine
regards,ice
regards,ice
on second thoughts lets not go to Camelot ,it is a silly place
Re: Cable problems
Thank you kind sir......job done....now for a Peroni.......
Mike
Mike
I should have collected beer mats
- tiger205
- Warrant Officer 1st Class
- Posts: 1800
- Joined: Thu Oct 23, 2008 11:21 pm
- Location: southampton
Re: Cable problems
same with me cliff, the single pin to + side of rx
Tony
Tony
"Er, der kämpft und Lebend davonläuft,
Lebt um einem anderen Tag zu kämpfen".