RC Tank Warfare community hobby forum

A video is worth a thousands words...in my case its a blessing! LOL

Note the servo control MG34

ENJOY!

http://youtu.be/j0OUodKIbyc

Well done Herr Fritz, that is a sweet looking and sounding T1. I like the idea with hull MG, how did you go about setting it up inside and with the controller? Great job dude...

Derek

Thank you Red Devil,

I used a second Receiver and plugged the mini servo into the aileron port.....so
when the Tank is NOT in motion I can use the left stick L & R motion to aim the gun.

The 1st Receiver powers the 2nd receiver ...I am not very experienced with transmitters
so I messed around till I found a way to make it happen.

Here is what I did with the rear formation light...its real glass from a camera flash tube.

http://youtu.be/0yWBmuAK8rc

EXCELLENT HERR FRITZ! The video does say a lot...shows you not only have a runner...but a performer too
that Haunted machine gun is really something else...and thanks for showing us your very well thought out wiring ...it is as clean as you described in your other post
better than I had imagined
I did notice the elusive Spaniard tank crew ran off with a set of your smoke launchers

What I really enjoyed was the gaze your kitty gave you.... like..."is it my turn to play with it dad ?"

Hope you had a fine Holiday season... Best of Luck in 2014

ALPHA

wow! Thanks!

Now for the Barrel elevation gearing I am using the large gear parts from two
Heng Long airsoft shooter mechanisms to build something similar to what I have seen on
the net and in Clarks Site.

At the moment my elevation thingamajig is just a servo wing and at the end of it is a ball like
thingy that rides in a channel connected the the other side of the recoil thing ...you know ...that doohickey thing

NOT MY PIC...its from the CLARK MODEL PAGE

that is so cool well done that man !

Good Morning,
Excellent! work, Herr Fritz. There is always a different and better way to do things.
regards,
Painless

wow

Thanks guys! A pat on the back never hurts LOL