Page 1 of 2

Tamiya Gepard (56003)

Posted: Thu Oct 03, 2013 8:13 pm
by JBdk
Hi...

Here is a couple of pics of my restored Gepard...it is a so called attic find, where it has been hidding for the past 30 years...I bought it for something like £30 and my plan was at first to sell it in parts but almost everything was there it only needed to be glued back on...the battery had been left in the chassis and due to that it had made some corosion so I had to take the chassis apart and give it a good clean up and a fresh layer of paint...
All in all it ended up being my cheapest Tank I spent £30 on the tank and another £35 for parts and paint... 8)

Image
As it was when I got it, the canons are fixed with double adhesive tape.. ;)
Image

Image
A look "down bellow" :)

Image
Down bellow after a clean up and fresh paint.

Image
Finished...the decals are the originals, they where nicely packed in a box together with the manual. :)
Image
Image

Image
Together with my Leopard 2 A6 and my Leopard 1 :P

Re: Tamiya Gepard (56003)

Posted: Thu Oct 03, 2013 9:24 pm
by PainlessWolf
Good Afternoon,
Great find there. I had one of these about 25 years ago but never got around to making it full on RC. Did you or are you going to set it up for radio control vs remote control? Beautiful piece of the past there.
regards,
Painless Wolf

Re: Tamiya Gepard (56003)

Posted: Thu Oct 03, 2013 9:53 pm
by JBdk
Hi...

It was set up with radio control when I got it...I have kept the old Acoms servos in it and only changed the speed controller to an electronic speed controller due to the safety...it would not be good if the old mecanical speed controller locked up and sent the tank full speed ahead to a brickwall.. ;)

Re: Tamiya Gepard (56003)

Posted: Fri Oct 04, 2013 12:18 am
by PainlessWolf
Good Afternoon,
*chuckles* No, that would not be good. As I recall, it was a fairly speedy thing for back then.
regards,
Painless Wolf

Re: Tamiya Gepard (56003)

Posted: Fri Oct 04, 2013 6:50 pm
by Red Devils
Great build JB, well done...

Derek

Re: Tamiya Gepard (56003)

Posted: Sat Oct 05, 2013 12:41 am
by ALPHA
Nice job..

Re: Tamiya Gepard (56003)

Posted: Sun Oct 06, 2013 12:33 pm
by Wildboar44
My God.....if there was such a thing as beauty in a tank this would be it !....Hmmm I want one :crazy:

Thanks for showing

Re: Tamiya Gepard (56003)

Posted: Sun Oct 06, 2013 1:11 pm
by hawkeye3guns
Hi I also have a gepard that I aquired in the mid 70's as a scrap tank to use in a Landing craft I was building, the lower hull and running gear are in great condition but some of the upper hull and especially the radar unit are in very poor condition I'm hoping to fully restore it one day, but is there any replacement parts still out there or have I got to scratch build any replacement bits I need having seen your model it made me get mine out of the loft again.
regards Denzil

Re: Tamiya Gepard (56003)

Posted: Sun Oct 06, 2013 1:40 pm
by JBdk
Hi Denzil...

You can get alot of parts for it on eBay...just search for 1:16 Tamiya Gepard...you can also go the whole way and buy Tamiya kit 36208 it is the reprint of the RC Gepard from the seventies but without the RC gear such as the transmission ect... :-)

Re: Tamiya Gepard (56003)

Posted: Sun Oct 06, 2013 2:06 pm
by hawkeye3guns
Thank you for that information its the main radar unit on the rear of the turrent, thats a wreck and the front detail on the foredeck ie. lights, mirrors and the towing stantions. I hoping to restore the vehicle to the same condition as the test vehicle that I fired at Oerlikon range at Ostenboden just outside Zurich in the early 80's.