Page 1 of 1
HL Panzer IV not responding
Posted: Thu Feb 07, 2013 3:58 pm
by Kye
Hello all
As per the title really.
it responds to the start engine button and seems to 'freeze' when shutting it down. The engine sound gets stuck half way through the shut down sequence. When the thing is running, no input at all works. I've checked cables and connection and everything is all in place.
Has anyone got any suggestions? I'm suspecting a stuffed control board.
Thanks
Kye
Re: HL Panzer IV not responding
Posted: Thu Feb 07, 2013 4:56 pm
by FreakyDude
Have you checked your battery? After that check your crystals and make sure they are plugged in well and you have solid connections.
Still have an issue then come back and let us know the results of the above
Re: HL Panzer IV not responding
Posted: Thu Feb 07, 2013 5:59 pm
by MichaelC
Sounds like battery to me. Tried charging it up full. If you are using stock HL wall wart it might be faulty and not charging the battery fully.
Re: HL Panzer IV not responding
Posted: Thu Feb 07, 2013 8:18 pm
by Kye
Both batteries are fully charged and they are HL ones. My King Tiger works fine on both of them.
Crystals are set just fine.
Still no results though. The headlights flash, it goes through the start up sequence, the headlights stop flashing, it runs at idle and that is how it stays until I shut the engine back down. Nothing works apart from the start/ stop. The machine gun button or cannon buttons don't either. Bugger.
Re: HL Panzer IV not responding
Posted: Thu Feb 07, 2013 9:29 pm
by MichaelC
Sometimes when I am out of range I get this as well with the 28Mhz receiver. I assume radio antenna is up and the receiver board is all connected up properly with the ariel hook-up in the tank ?
Re: HL Panzer IV not responding
Posted: Fri Feb 08, 2013 11:30 am
by lister fiend
Hang on, It's a taigen 2.4 GHz one?
Other than a loose wire somewhere
It's proberbly the board
Can you swap it with ur kt board
To check?
Lister
Edit: if your Lucky
The tx & rx might of unbound itself
Re: HL Panzer IV not responding
Posted: Fri Feb 08, 2013 3:31 pm
by MichaelC
Taigen is all in one so you will have to replace the whole MFU. If it is RX-18 then you could try swapping out the receiver board first to see if it is the board itself. Your KT is probably Taigen right ? So you can swap it out and see if it works on the Panzer IV.
Re: HL Panzer IV not responding
Posted: Tue Feb 19, 2013 9:07 pm
by Kye
I reckon the board is toast. I could change it with the KT, but the KT has the newer 2.4 Ghz system and I can't be doing with changing it over. I'll get a new RX and see what happens. In time the KT board will come over to the P4 once I upgrade it to El Mod or something similar.
Thanks for the input!