Two years are gone since I have finished my HL Tiger 1 build. Meantime I found the one or other mistake, also the camouflage pattern was not correct for me. So there were actually two ways, sell or again a rebuild. The one possibility is probably a big loss business and I lost my entry model or going but once again lend a hand - also costs once abundant money and time, but the latter was my choice.
The new conversion should include the following changes:
• change turret pivot and position
• change pivot point of the gun to the original point
• several changes to the engine deck
• add splinter protection ring
• changes at the turret hatches
• change of front-MG and lighting front
• add rear lighting, changes at the exhaust system
• installation/change of angle mirror
• change electronics from HL to ElMod, add a new speaker and a charging jack
• new paint with an other camouflage pattern
Meantime is this conversion program already completed. I will not show a complete report about the individual steps, but I will show you some photos during the building and some photos of the finished Tiger.
It goes on in part two.
