Boosting a H.L. smoke unit
Forum rules
If you're planning on posting a log of your build please use the relevant build sections.
If you're planning on posting a log of your build please use the relevant build sections.
-
- Lance Corporal
- Posts: 215
- Joined: Tue Jan 04, 2011 8:39 pm
- Location: Charnwood Leicestershire
Re: Boosting a H.L. smoke unit
Yes you can dispense with the small square connector and connect the wires directly, as the connector is mainly to connect the pump motor resistors to the rest, but as Pathfinder said it won't work as well without the pump running, the fan is a booster so not intended to be the sole means of working the smoker without a lot of alteration.
Jonger
- tanker 242
- Corporal
- Posts: 407
- Joined: Sun Dec 09, 2012 5:14 pm
Re: Boosting a H.L. smoke unit
thanks guys but my smoker unit has totaly had it ,for some reason ,so have had to send off for a replacement , tanker 242.
- tanker 242
- Corporal
- Posts: 407
- Joined: Sun Dec 09, 2012 5:14 pm
Re: Boosting a H.L. smoke unit
hi guys need help replacement smoke unit arrived today ,but when i fitted it & the fan in all wired correctly nothing the pump motor wont work & niether will the fan every thing ealse works fine , any ideas as to whats wrong . tanker 242
Re: Boosting a H.L. smoke unit
tanker send a pic. Also, is it proportional smoker ? When I fitted my proportional smoker I found out that the pump and the fan barely moves if the motors is not running. I guess the fan is drawing additional power so unless the motors are loaded the smoker won't even start......
- tanker 242
- Corporal
- Posts: 407
- Joined: Sun Dec 09, 2012 5:14 pm
Re: Boosting a H.L. smoke unit
hi michaelc its a non proportional unit it works ok in my kv 1 , have even swaped them round but its just not working in the pzr 1v , i wonder iff i have a fault in the rx 18 , but every thing ealse works ok , as the pump motor stoped on the old unit before i fitted the fan ? & the fan works ok on the outher units so no problems with the fan . tanker 242
Re: Boosting a H.L. smoke unit
tanker this is all pretty straight forward wiring. I guess try it without the fan to make sure it is not a dud first and then go from there.
- tanker 242
- Corporal
- Posts: 407
- Joined: Sun Dec 09, 2012 5:14 pm
Re: Boosting a H.L. smoke unit
hi michaelc the fan & smoke unit works in the kv1 , but when i put it in the pzr 1v no pump motor or fan . the new one works in the kv1 as well as the fan .? tanker 242
Re: Boosting a H.L. smoke unit
Did you turn the smoker switch on in the panzer IV ? You might have fired the RX-18 then on the panzer IV perhaps.
- tanker 242
- Corporal
- Posts: 407
- Joined: Sun Dec 09, 2012 5:14 pm
Re: Boosting a H.L. smoke unit
yes turnd switch on , every thing works on the pzr 1v turret moves l/r barrel up/down recoil& flash , f/b driveing .l/r turning [just no pump or fan] ?