Three Tigers

[Edwin]

The third tiger is slowly finished this week in any case.

Here I have the main wiring harness of the tank ......



And by the way, I am still in the last two days for car and transmitter employs coordinated. This is somewhat difficult since these channels do not offer those options usually used by me, but now he goes ....

[Edwin]

The wiring is done slowly.

Even the LED's provided by the headlamp and the MG with a matching resistance and solder it to the connector.





The connections to the module Beier not forget.



And a little clean up in the hull.



Then the tower of the series, the first obstacles as I can.



Since I still have begun to build the cradle with the power requirements. Tomorrow will be finished so the technique.

[Edwin]

Today, the tiger should at least be structurally finished .

First off even attach the servo for the recoil .



Then the second servo for elevation each . I'm using since only servos with metal gears , as these sometimes bear a blow and not go the same gear broken.



To drive the switch to the speed camera I've thought of something new . Since the gun is not usually play out , it was difficult to place a button so that it always triggers . Well -built probe enable the large tolerances were not always successful . Therefore I now have a push rod that is installed , just before the switch. Thus , the tube can move as it wants and the button is still addressed and the flash fires .





Now, he stands there and tomorrow I will deal with programming and setting of the sound module and a few remaining tasks . He sollter then can go to its new owner this week .

[PainlessWolf]

Good Morning,
Solid and structurally amazing work. I have a couple of questions if I may? When someone orders one of these Tigers from you, do they just send you a tank shell (turm, deck and upper and lower hull and tracks and sprockets\idlers, etc) and then you do the inner workings to fit? Do you do this for other tank types than the Tiger 1? Thank you in advance.
regards,
Painless Wolf

[Edwin]

Hi Painless Wolf

My business is primarily the technical order model.
I have often found that my custom parts like chains, send rollers and so on and then I build a tank from the extent it is feasible and useful.

I build because of course other tanks.
Which you think?

regards Edwin

[PainlessWolf]

Good Morning,
Primarily, I had things in mind like the Ferdinand or the Sherman Jumbo or even the PzKpfw IV based Brumbar.
regards,
Painless Wolf

[Edwin]

Good evening ..... for me it is at 6 clock

Something I can already do.

but my specialty is the main thing, the technical conversion. If I were to build a tank and paint finished to the last detail, it is usually due to the high workload relatively expensive and these things want my customers to make themselves mostly.

I've rebuilt several of Hooben Elefant eg.

There are Christian Ludwig of a wonderful metal pan in which I then built a reasonable drive and the suspension of Asiatam.

A Sherman I have not built yet, I offer this for the armor-IV, an aluminum pan at the time of the suspension of Asiatam I use this and also get functional.

Otherwise, I also build almost always Brushlessantriebe and partly self-built and adapted Leiistung gear. This was with my aluminum pan from Tiger, Bengal Tiger, Hunting Tiger and Panther also true outdoor gear.

[PainlessWolf]

Good Morning,
That is very interesting, especially the Bengal Tiger and Panther. Thank you for the information.
regards,
Painless Wolf

[Edwin]

You can browse a little on my website so times.

I must, however, once again revise and bring up to date.

apamotec.de.tl

[PainlessWolf]

Good Morning.
Thank you for the link. It would be very interesting to see what you could do with a Mato Sherman.
regards,
Painless Wolf