Page 4 of 7
Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Sun Jun 23, 2024 4:46 pm
by MonsieurTox
Herr Dr. Professor wrote: ↑Mon Jun 17, 2024 5:19 pm
I think you have the correct vertical streaking for the Sherman's days and nights in dust and rain. Have courage; go a little bit at a time, and your M4A3E8 will look great.
Then, too, I do not know if you can use the "mule" but it would make a fine hull even for a stock HengLong Sherman.
Thank you Herr Dr. Professor ! I finally went for a less weathered sherman, when checking my B&W pic again, I found it a bit too extrem.
So, I designed the recoil system.
I found a video of a M4A3E8 firing. Angle of view as ideal as it was a near perfect side view. I have been able to scale it to 1/16 to measure the recoil travel, which is around 15 mm. It was nice to notice the tank itself does not move at all when it fires (which was not the case with the 75mm guns).

- no-recoil.jpg (350.04 KiB) Viewed 2717 times

- recoil.jpg (225.08 KiB) Viewed 2717 times
Everything was going fine until I plugged and tested it... The servo was going the wrong way and I did not find any way to inverst the servo on the TK 6.1. I think it's impossible ! So I had to disassemble the recoil frame (well destroy it since everything was glued), and glue all the parts the opposite way to get a mirrored recoiol frame so the servo would turn the wrong way. In the end it works fine, I'll take a vid eventually. I chose to not use the metal barrel because it is not hollow and maybe I'll add a LED and smoke later.

- M4A3E8_59.jpg (1.16 MiB) Viewed 2717 times

- M4A3E8_60.jpg (895.9 KiB) Viewed 2717 times

- M4A3E8_61.jpg (1.17 MiB) Viewed 2717 times
Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Sun Jun 23, 2024 4:50 pm
by MonsieurTox
Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Sun Jun 23, 2024 6:45 pm
by ColemanCollector
Tank's looking great. Love the mild weathering!
I'm slowly building up a Grizzly with the TK6.1 board and the Mato metal turret and yup, the recoil is reversed. Rather than rebuild the servo setup, I used a servo reversing unit from aliexpress. Plug and play and does the job!
Mike.
Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Sun Jun 23, 2024 7:14 pm
by MonsieurTox
Thanks for the tip Mike, I may buy a couple just in case!
Can't wait to see the Grizzly!
Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Mon Jun 24, 2024 11:08 pm
by Herr Dr. Professor
I am amazed by the ingenuity you RC AFV Masters demonstrate. (I liked the photos, too. The fellow pulling the "remote control" lanyard in the photo of the Sherman firing has the right idea to stay away. On the other hand, the big guy with no hearing protection must have his brains rattled out.

)
Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Tue Jun 25, 2024 9:00 am
by MonsieurTox
Herr Dr. Professor wrote: ↑Mon Jun 24, 2024 11:08 pm
I am amazed by the ingenuity you RC AFV Masters demonstrate. (I liked the photos, too. The fellow pulling the "remote control" lanyard in the photo of the Sherman firing has the right idea to stay away. On the other hand, the big guy with no hearing protection must have his brains rattled out.

)
Thank you !
Yeah that's not very smart from that guy !

Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Tue Jun 25, 2024 9:06 am
by Kaczor
Great looking Sherman!
Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Tue Jun 25, 2024 10:03 am
by HERMAN BIX
Even I like that one
As a Shermaphobic not many of them get me, but every once & a while one comes along that strikes a chord..............
Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Thu Jun 27, 2024 10:31 pm
by MonsieurTox
HERMAN BIX wrote: ↑Tue Jun 25, 2024 10:03 am
Even I like that one
As a Shermaphobic not many of them get me, but every once & a while one comes along that strikes a chord..............
Thank you for the nice compliment mister Bix !

Re: Sherman M4A3E8 (I Love Kit, integral RC conversion)
Posted: Sat Aug 24, 2024 10:27 pm
by MonsieurTox