Hi,
Been offline a bit recently but managed to get some more building done. So firstly the wiring is routed through the base of the light and inside the hull via a resistor to a mini tamiya connector. This matches the connector I have on my board with the pico switch on. As ever a couple of piccies: -
1. Cable (heat shrinked) routed into the hull
2. Showing inline resistor and Tamiya mini connector
3. Finally an overview of my Pico Board layout (revised picture from earlier)
My first build - Tamiya Jagdpanther
Re: My first build - Tamiya Jagdpanther
Also repalced the moulded in blobs that represented, in the loosest of ways, the lifting hooks around the vents.
Hollowed out part F29 And replaced the blobs that the rear hatch would open onto with some bent brass strip.
Hollowed out part F29 And replaced the blobs that the rear hatch would open onto with some bent brass strip.
- Red Devils
- Staff Sergeant
- Posts: 872
- Joined: Sun May 06, 2012 2:38 pm
- Location: Edmonton, Alberta, Canada
- Contact:
Re: My first build - Tamiya Jagdpanther
Lookin great Geoffjag, you have an eye for detail. Well done...
The Princess Patricia's Canadian Light Infantry
First in the Field - Since 1914.
First in the Field - Since 1914.
Re: My first build - Tamiya Jagdpanther
Hi Jeff,
Did you get any further with this one?
I'm very curious to see if your DX6i settings worked out ok, your explanation of the set up was very clear and I wanted to know if you had to make any further adjustments.
Did you use the Dual rate switch for the elevator to change between 100% and 125% or just set up the DMD for 100% then change the setting to 125%?
I'm just about to purchase a TX for my King Tiger, Leopard and JS-2 and am still undecided between the DX6i and the Planet T5 system.
Best Regards
Keith.
Did you get any further with this one?
I'm very curious to see if your DX6i settings worked out ok, your explanation of the set up was very clear and I wanted to know if you had to make any further adjustments.
Did you use the Dual rate switch for the elevator to change between 100% and 125% or just set up the DMD for 100% then change the setting to 125%?
I'm just about to purchase a TX for my King Tiger, Leopard and JS-2 and am still undecided between the DX6i and the Planet T5 system.
Best Regards
Keith.