RC Tank Warfare community hobby forum

Ecam wrote: ↑Thu Sep 26, 2024 10:59 pm I don't know the Toro board, but you may soon have an answer from one of the smarter members...

I replaced the Toro board with the Beier SFR-1-HL board.

Well after avoiding another hurricane last night, (they keep missing Alabama) I fired up the Beier SFR-1-HL software and have resolved my tracking issue, tweaked the sound some more, now I need to figure out how to get the recoil and Flash back on my Canon.

Just visited Photobucket. $50 a year I don't think so! Need a freebie site.

Imgur has been my friend...

Ecam wrote: ↑Fri Sep 27, 2024 2:07 pm Imgur has been my friend...

Okay I'll try that next thank you.

My new radio did not have a self centering throttle stick so I decided to put the kit in. Just my luck the kit was missing one of the two pins required. No problem, I took a coat hanger and made one and now I have a self-centering throttle.

Hello and welcome from the West Coast of Scotland, on the beautiful Argyle Coast.

Meter rat wrote: ↑Fri Sep 27, 2024 2:59 pm Hello and welcome from the West Coast of Scotland, on the beautiful Argyle Coast.

Thank you for the warm welcome. I'm going to have to get to Scotland one day. I'm 54% Scott the rest is mostly Irish and Welsh. I guess that's where my red hair and bad temper come from.

Hoghappy2000 wrote: ↑Fri Sep 27, 2024 2:30 pm My new radio did not have a self centering throttle stick so I decided to put the kit in. Just my luck the kit was missing one of the two pins required. No problem, I took a coat hanger and made one and now I have a self-centering throttle.

Did it work? Fine fabrication!

Ecam wrote: ↑Fri Sep 27, 2024 7:11 pm

Hoghappy2000 wrote: ↑Fri Sep 27, 2024 2:30 pm My new radio did not have a self centering throttle stick so I decided to put the kit in. Just my luck the kit was missing one of the two pins required. No problem, I took a coat hanger and made one and now I have a self-centering throttle.

Did it work? Fine fabrication!

Yes sir. Coat hanger wire is the perfect diameter.Just cut and file the rough ends down.