RC Tank Warfare community hobby forum

Interesting (re)use of temporary road/runway material.

Thanks guys for your help and support!
this external fuel tank topic is curious but whatever ... I´ll see

Next step: before finishing the hull with all details I switched over to the turret.

First I put on a cast structure at the 3D printed turret parts (series produced turrets will be casted too).

Some little work happend at the turret.

3 small crates…





…the ammo port and some other stuff.



The turret is finished so far







Freddy

Good afternoon,
This is a work of Art. Clean, detailed, you can see how good it's going to look assembled and under paint.
regards,
Painless

Absolutely brilliant work. Following along

Smashing work Freddie

Wow, superb work.
I better start saving my pennies then.

Thanks guys! Hope I can fulfil your expectations

With adding some little details at the hull, i.e. maintenance cover…



…engine cover locks…



…muffler straps…



…rear light panel…



…building of the Matilda prototype is done

















best regards,
Freddy

Amazing work so well done

When I'm done with Cromwell, I'll be waltzing Matilda! It should make an amazing kit, and I'd be surprised if it's not sold in appreciable numbers. I have to say that apart from the meticulous detailed work, the photographic presentation's pretty impressive too. Outstanding, in fact