RC Tank Warfare community hobby forum

Ok thanks but how do i fit them in

pull out the socket you will see how and were they go[ 2 slim prongs ] but if I were you get yourself a taigen t5 2.4 from welsh dragon mods they come with instuctions .......

you cant with an abc transmitter its fitted internally with three crystals that match upto the older boards.. the transmitter you need has a hole where the abc slider is and at the bottom are two smaller holes that the crystal pins push into

Hi Applelover786 , Welcome to the forum btw , the Transmitter you have shown is the correct type - the small black oblong plug in the lower right corner is where the crystal will go , this cover will just pull out ( Non RX18 radio sets have a 3 position switch ) Try changing the tracks over , and see if it still happens on the same side , easiest way is to remove the central caps on the drive sprockets and undo the allen bolt holding them on . The whole sprocket can come off , this will give enough slack in the tracks to remove them . Also the rear idler wheels often have too much slack in them , this makes the tracks jump off , a common problem . There are aftermarket adjusters available that will cure this . Blimp .

Thank you guys soooo much il keep you up to date with tank

Thank you all you guys
You lot are the pros

Does anyone know how to make a volume switch

I believe the volume pot has a very low Ohm resistance. It may be tough to simply find a replacement for it other than simply getting one of the originals. Here is the whole package deal. http://www.ebay.com/itm/Heng-Long-1-16- ... 3cdd66bd79