RC Tank Warfare community hobby forum

a good pillar drill setup will convert them to tamiya axles

hi rob if you look at the back of the wheels they are a littel longer than the tamiya ones so will have to wait and see what i can do with a set when they come thanks dave

I bought the asiatam late wheels for my tiger and didnt get any pins so i used M3 allen bolts and drilled the wheels to 4 mm and added a brass sleeve of 4mm O.D/ 3mm I.D

the henglong pins IMHO are way to sloppy and move all over the place

i have drilled the metal heng long arms and put grub screws in to hold the axels in this is a pic of the wheels just pushed on for a picture

If you need any taking down to size i could mill some down for you to fit the tamiya tiger

will see wot i can do when i get the i hope the jagdpanther ones will be ok to we will see when they send me the sample

i have an asiatam hull as well so could offer them up and see what differences there are

ooohhhhh did you say jagdpanther ones???????

yep i did say jsg ones soon i hope

will these wheel sets take ball bearing races