RC Tank Warfare community hobby forum

You can't have the flash and airsfot at the same time? in the same tube, this plate is intended, it seems to me? to have a separate power supply from the smoke system

Why not? You can take a narrower tube and combine it with the flash wire, so it's purely an electronic question.

I don't really understand, how you will accommodate the flash and the passage of the ball, in a tube? even smaller? except not using the ball shooting function?

NVM...

Hi, so the clip I posted seems to show it hooked up to a tk50. I have this board and have got the recoil and smoke working.

The tk50 has a setting for the upper hull of cannon smoke. This details that in this setting it works the air pump.

The tk60 doesn't seem to have this setting. I dont know how you would supply continuous power to the pump to push the smoke. I would contact clark and ask them. I have sent emails before and they're good at getting back to you.

As for install for the tk50 I ran a separate power off the power switch, then I assembled everything to a switch module. Changed the settings on the clark board on menu page 4 then it all worked.

I hope you get the tk60 smoking, as for using a bb with it I don't think that's a starter, however I didn't try that, can't see how you would get it all down the barrel.

Sent from my SM-G986B using Tapatalk

Gillaspy2005 wrote: ↑Wed Aug 21, 2024 10:40 pm Hi, so the clip I posted seems to show it hooked up to a tk50. I have this board and have got the recoil and smoke working.

The tk50 has a setting for the upper hull of cannon smoke. This details that in this setting it works the air pump.

The tk60 doesn't seem to have this setting. I dont know how you would supply continuous power to the pump to push the smoke. I would contact clark and ask them. I have sent emails before and they're good at getting back to you.

As for install for the tk50 I ran a separate power off the power switch, then I assembled everything to a switch module. Changed the settings on the clark board on menu page 4 then it all worked.

I hope you get the tk60 smoking, as for using a bb with it I don't think that's a starter, however I didn't try that, can't see how you would get it all down the barrel.

Sent from my SM-G986B using Tapatalk

Thanks for the reply. I wrote to clark a few days ago but haven't gotten a reply yet.

Just connect the power supply and firing light