RC Tank Warfare community hobby forum

designing the screw mounts for the springs

Printed the front plate. finally figured out what kind of gun traverse design ill be using.

Giganaut wrote:

Very good indeed

finally got time to update on the tank.


i decided to name this Jagdpanzer E-100 as Siegfried.

sooo here are the updates done to it.

did work on the roof details to cut slots and openings for the stuff to be placed on it


printed the front roof


and now for the engine deck



alittle something with a 1:16 scale Death Korps of Krieg General model

printed the lower front plate


the grooves are to accommodate the gearbox's housing



on the tank itself

Hell of a job mate
How much of that reel of filament is left !!?
For the barrel, you might consider looking at cheap fishing rods, they taper nicely and the right one will bound to have a section in it that will suit the dimensions of your barrel.
Plus they are light but strong .

HERMAN BIX wrote:Hell of a job mate
How much of that reel of filament is left !!?
For the barrel, you might consider looking at cheap fishing rods, they taper nicely and the right one will bound to have a section in it that will suit the dimensions of your barrel.
Plus they are light but strong .

currently printing the floor and i am standing by to refill the filament reel. hell. this tank would probably need about 1 and 3/4 of the filament reels to completely finish it.



here's today's update from last night's printing run, the lower hull bits are printed.

added the gun mantle, hull floor, hull braces for the engine panel support and now wobble on the lower part is eliminated




finished printing the gun's base mount to be attached to the front superstructure panel





added the first part of the track side armor. 1 part out of 6...


my boi is W I D E

I’m loving this
Cheers
Wayne


Sent from my iPhone using Tapatalk