Page 2 of 2
Re: Clark recoil servo issue
Posted: Mon May 20, 2019 10:55 pm
by Jofaur86
What i mean is that the plastic pinion does not have grooves,you have to press very hard for the crown to make ist mark if not at the end of the rare the servo will turn, but will not drive the pinion,
If you hold the pinion with two fingers,and operate the servo,it must lock at the end of the race
!
Re: Clark recoil servo issue
Posted: Tue May 21, 2019 12:28 am
by AshMann
Jofaur86 wrote:What i mean is that the plastic pinion does not have grooves,you have to press very hard for the crown to make ist mark if not at the end of the rare the servo will turn, but will not drive the pinion,
If you hold the pinion with two fingers,and operate the servo,it must lock at the end of the race
!
The plastic pinion is already pressed on the crown
Re: Clark recoil servo issue
Posted: Tue May 21, 2019 1:02 pm
by Jofaur86
Hello,
It's still weird? Perso had a problem with this type of recoil,i do my test with a servo tester easier than with th transmitter,would be possbleto hve photo ?
https://www.amazon.fr/testeur-de-servo- ... amazon-aps
Re: Clark recoil servo issue
Posted: Tue May 21, 2019 2:34 pm
by AshMann