RC Tank Warfare community hobby forum

Great work man, looking fw to follow this build

Tow pin and stowage bins are great.
I am going to try the cast armour trick on my Jagdtiger.

Thanks guys.

@Herman - is your JT the Torro one? That's my next heart's desire once my finances are recovered. Is the Torro JT any relation to the MaTorro one? I believe that the upper Hull needs work due to a difference in angle between the hull sides and casemate sides.

It's also shorter needs upper and lower hull mods ,but Herm is an expert at those mods

An expert is a drip under pressure
Mine is a Matorro one, no way I will justify the outlay no matter how good they are !
The Matorro needs a lot of mods to get it close to looking right, and no matter what, it will never be a. Torro.
Sure is an enjoyable challenge to see if I can get it looking right.

SheepStrangler wrote:Thanks guys.

@Herman - is your JT the Torro one? That's my next heart's desire once my finances are recovered. Is the Torro JT any relation to the MaTorro one? I believe that the upper Hull needs work due to a difference in angle between the hull sides and casemate sides.

Here is my Torry ( 2016) JT straight out of the wooden Box . superstruckture and lower hull is now ( atleast what they say) is correct. ( still think the idler Wheel is a tad to fare back . )



and 'chopping'

That looks awesome - I must have misunderstood the threads I viewed on the subject. I thought the hull & casemate sides were supposed to be at the same angle. Do you have a thread on this build? I'm interested in learning some more